SGX VIBRATOR MOTOR
15 Jun 12 7-17
HyperPoolShaker
Work Area Environment
A well-lighted area with sufficiently large work-surface area is required to work on the motor. The
work surface should be clean to prevent contamination of the new bearings and motor interior.
Safety
The following WARNINGS apply to the bearing replacement procedure. Be sure to read and
understand these WARNINGS before proceeding.
WARNING! MOTOR HOUSING BECOMES HOT DURING OPERATION AND
MAY CAUSE SEVERE BURNS. DO NOT TOUCH MOTOR HOUSING DURING
OR IMMEDIATELY AFTER MOTOR H
AS BEEN OPERATING.
WARNING! ALL OPERATING AND MAINTENANCE PERSONNEL MUST READ
AND UNDERSTAND ALL SAFETY INFORMATION IN THIS MANUAL BEFORE
WORKING WITH THE EQUIPMENT.
WARNING! HIGH VOLTAGE MAY BE PRESENT. BE SURE FUSED
DISCONNECT SUPPLYING ELECTRIC PO
WER TO THIS EQUIPMENT IS
OPEN. LOCK OUT AND TAG OUT POWER SUPPLY TO PREVENT
ACCIDENTAL APPLICATION OF POWER WHILE MAINTENANCE AND/OR
ADJUSTMENTS ARE IN PROGRESS.
TO PREVENT SERIOUS EYE INJURY OR PERMANENT LOSS OF
WEAR SAFETY GLASSES DURING THIS PROCEDURE.
Bearing Replacement
The procedure below describes replacing bearing on one end. Repeat the procedure for the
second bearing.
Remove vibrator motor from equipment before performing bearing
(refer to Motor Removal and Installation). Bearings will fail
if new bearings become contaminated during replacement.
To Next Page
Loading...
Need help?
General
