LBB Series Oven Owner’s Manual ASSEMBLY & SETUP
Version 13 27
Copyright © 2011 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
To wire the LBB Series Oven (for
units requiring hardwiring):
1. Remove the top cover for access
to the connector block (Figure 7).
2. Run the wire through the rear access
hole (Figure 8) and connect the
appropriate wires at the connector
block (Figure 9).
Figure 7. LBB Series Oven with Top Removed.
Figure 8. Wiring Access through Rear of Oven.
Figure 9. Close-up of Connector Block.