OPERATION LBB Series Oven Owner’s Manual
32 Version 13
Copyright © 2011 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
5.4. Working with the Control Instrument
Danger!
Failure to heed warnings in this instruction manual and on the
oven could result in personal injury, property damage or death.
The LBB Series Oven is factory tested and the controls have been factory-set for normal
operating conditions.
In most applications it is not necessary to alter the oven’s
settings, except for Setpoint.
This section contains information for changing setpoints, programming modes, and
displaying temperature, along with instructions for oven zone calibration, parameter setup
mode and troubleshooting.
5.4.1. Change Setpoint
Warning!
Never operate oven at a temperature in excess of the maximum
operating temperature of 204°C (400°F).
To enter Setpoint on the Control instrument:
1. Press . SP will light.
2. Use ▲ and ▼ to set the operating temperature.
a. The right decimal point LED will flash indicating the Setpoint is being changed.
b. The right decimal point LED stops flashing when the new value has been entered.
3. Press to enter the Setpoint.
4. Press again to display the process temperature.
To Next Page
Loading...
Need help?
General
