C244, 320207, REV B LCC_LCD1-16/51 Oven Owner’s Manual
©2021 ITW EAE. All rights reserved. Despatch is a registered trademark in the U.S. and other
countries. No part of the contents of this manual may be reproduced, copied or transmitted in any form
or by any means without the written permission from ITW EAE - Despatch, unless for purchaser's
personal use.
b. The completion of the burn-off period should be based on the particle
level in the oven or smoke-free exhaust and minimal odor level.
c. Check the filter hold-down nuts after burn-off and tighten as necessary.
d. For best oven particle control, this step should be repeated on a regular
basis.
If the equipment must be moved after the burn-off process, use
considerable care.
• The binder which strengthened new filters is now burned-off
and the media is very fragile.
• Rough handling of either the filter alone or the equipment with
the filter installed is not recommended as it may tear the media
and lead to reduced filter efficiency.
• Removal of the filter after heating can also result in damage to
the frame seal and is only recommended when replacing the
filter.
To Next Page
Loading...
Need help?
General
