Model TP-700
TP-700 Instruction Manual Rev. 4.1 Page 36 of 42
8. TP-700 Sensor Warranty
8.1 Plug-in H
2
S Sensor Warranty
Detcon Inc. warrants, under normal intended use, each new plug-in H
2
S sensor (PN 370-010000-700) for a ten
year period under the conditions described as follows: The warranty period begins on the date of shipment to
the original purchaser and ends ten years thereafter. The sensor element is warranted to be free of defects in
material and workmanship. Should any sensor fail to perform in accordance with published specifications within
the warranty period, return the defective part to Detcon, Inc., 4055 Technology Forest Blvd., The Woodlands,
Texas 77381, for necessary repairs or replacement.
NOTE: The warranty will not be honored if evidence shows that the sensor cell was damaged
by moisture exposure due to improper handling and protection during periods of removed power
or storage. The sensor cell must be protected during periods of removed power or storage by use
of a Dust Cap (P/N 602-003306-0TP) and a Desiccant Packet (P/N 960-240010-000).
Terms & Conditions
• The original serial number must be legible on each sensor element base.
• Shipping point is FOB the Detcon factory.
• Net payment is due within 30 days of invoice.
• Detcon, Inc. reserves the right to refund the original purchase price in lieu of sensor replacement.
8.2 ITM Electronics Warranty
Detcon Inc. warrants, under intended normal use, each new Model 700 ITM to be free from defects in material
and workmanship for a period of two years from the date of shipment to the original purchaser. All warranties
and service policies are FOB the Detcon facility located in The Woodlands, Texas.
8.3 Terms & Conditions
• The original serial number must be legible on each ITM.
• Shipping point is FOB the Detcon factory.
• Net payment is due within 30 days of invoice.
• Detcon, Inc. reserves the right to refund the original purchase price in lieu of ITM replacement.
To Next Page
Loading...
