Detcon TP-700 - 10 Revision Log

Model TP-700
TP-700 Instruction Manual Rev. 4.1 Page 40 of 42
10. Revision Log
Revision
Date
Changes made
Approval
2.3
12/16/2008
Previous revision.
N/A
2.4
04/25/2011
Removed Teflon note in Section 2.5. Added Revision Log Section
10.
LU
2.5
07/11/2011
Added inrush current information to Specifications section.
Addend wiring and dimensional drawing for aluminum condulet
LU
2.6
04/16/2012
Changed the use of cable type, made changes to the Modbus
Register Map.
LU
2.7
08/07/2012
Updated spare parts list, corrected specifications
BM
2.8
01/07/2013
Updated ATEX approvals label, updated EN standards that sensor
assembly meets. Updated ATEX listing in Specifications
BM
2.9
04/02/2013
Updated ATEX installation instructions regarding use of ring
terminal for earth ground using screw and lock-washer. Updated
guidelines for metric special fasteners used in 700 assembly
BM
3.0
10/25/13
Updated for 4-20mA errors
LU
3.1
11/20/13
Correct Modbus™ Register Map
LU
3.2
12/19/13
Update Calibration to include Wind Guard
BM
3.3
02/28/14
Update 4-20mA wiring, and specifications
BM
3.4
03/07/14
Add notation on use of desiccant pack with sensor cell
BM
3.5
08/07/14
Updated Calibration Section
BM
4.0
06/16/16
Update cert specs, update technical information
MM
4.1
06/05/18
Updated Conduit Seal in Section 2.5
MM