Detcon TP-700 - Appendix; Specifications

Model TP-700
TP-700 Instruction Manual Rev. 4.1 Page 39 of 42
9.2 Spare Parts, Sensor Accessories, Calibration Equipment
Part Number Spare Parts
S927-xx0000-xxxx
1
TP-700 Intelligent Sensor Module (ITM)
S967-xx0xxx-xxxx
1
TP-700 ITM with Lower Housing, Cell, and Splashguard
602-003280-000
TP 700 Housing Bottom Assembly (includes Flame Arrestor)
370-010000-700
Replacement Plug-in H
2
S sensor
500-003087-100
Transient Protection PCA
602-003306-0TP
Dust Cap 1.5" Thread with Desiccant Pack
960-202200-000
Condensation Prevention Packet (for J-Box replace annually)
960-240010-000
Desiccant Protection Packet for Cell
Sensor Accessories
897-850800-010
NEMA 7 Aluminum Enclosure less cover – 3 port
897-850400-010
NEMA 7 Aluminum Enclosure Cover (Blank)
897-850801-316
NEMA 7 316SS Enclosure less cover – 3 port
897-850401-316
NEMA 7 316SS Enclosure Cover (Blank)
613-120000-700
Sensor Splashguard with integral Cal-Port
602-003306-0TP
Dust Cap 1.5" Thread with Desiccant Pack
943-002273-000
Hazardous location dust guard
327-000000-000
Programming Magnet
960-202200-000
Condensation Prevention Packet (for J-Box replace annually)
960-240010-000
Desiccant Protection Packet for Cell
Calibration Accessories
943-000000-000
Calibration Wind Guard
985-241100-321
In-Line Humidifying Tube
943-000006-132
Threaded Calibration Adapter
943-020000-000
Span Gas Kit: Includes calibration adapter, In-Line Humidifying
Tube, 200cc/min fixed flow regulator, and carrying case.
(Does Not include gas).
942-010112-010
Span Gas cylinder: 10ppm H
2
S in air (for 20ppm range)
Contains 58 liters of gas and is good for 80 calibrations
942-010112-025
Span Gas cylinder: 25ppm H
2
S in air (for 50 and 100ppm ranges).
Contains 58 liters of gas and is good for 80 calibrations
943-090005-502
200cc/min Fixed Flow Regulator for span gas bottle
943-000GMI-CAP
TP-700 Adapter Cover used with General Monitors glass ampoule
breaking cup.
Recommend Spare Parts for 2 Years
S927-xx0000-xxxx
1
TP-700 Intelligent Sensor Module (ITM)
602-003280-000
Housing Bottom Assembly (includes Flame Arrestor)
370-010000-700
Replacement Plug-in H
2
S sensor
500-003087-100
Transient Protection PCA
960-202200-000
Condensation prevention packet (for J-Box replace annually)
1
Contact Detcon Customer Service for a complete part number