3300-0188-0M Rev L y apex Digital Scale Owner’s 29
EVENT COUNTER
Your apex® Digital Clinical Scale has been designed with an Event Counter type of security
seal. When selected, the scale will display two numbers representing the Calibration and
Configuration counters.
Calibration Counter (!)
The calibration counter is incremented when a value in the calibration part of setup is
changed ($, -0;, 3, *9, -!;, 00#;, '%#, !, 9<, &($). The counter is only
incremented 1 time even if more than one parameter is changed in setup.
Configuration Counter (+)
The configuration counter is incremented when a value in the configuration part of setup is
changed ($'#, #;9, *9, *9, '*2, (9, 00;, 3(, #'9, 00)0, *, *`;,
6/3). The counter is only incremented 1 time even if more than one parameter is changed
in setup.
To Review the Event Counter:
1.
Pr
ess the
key to turn the scale on.
2. The scale will perform a display test (turn on all segments and annunciators) and then
change to the show the software revision for a few seconds.
3. Next, the display will change to the Weight Display with the Æ0Å (ZERO) and [\
(STABLE) annunciators turned on to show a stable, center-of-zero weight condition.
4. Press and hold t
he
key.
5. The display will show height for a short period of time, followed by the software revision.
6.
R
elease
the
key.
7. The display will change to show ! (Calibration Counter) on the small upper seven-
segment display and up to a 3-digit number on the large lower seven-segment display
for approximately two (2) seconds.
8. Next, the display will then show + (Configuration Counter) on the small upper seven-
segment display and up to a 3-digit numbers on the large lower seven-segment displa
y
for
approximately two (2) seconds and then change to show all dashes.
NOTE: If your scale is the model apex-C (equipped with the Redbird Wi-Fi and
Bluetooth (BLE) wireless transmitter), additional information will be shown after the
configuration Counter. Refer to the Setup and Operation Manual for apex® Clinical
Scales with Wi-Fi and Bluetooth (3300-0320-0M), section Display Scale Wi-Fi and
Bluetooth Settings for additional information and instructions.
9. To return to normal operation, press the
key or press the key to turn off scale.
To Next Page
Loading...
Need help?
General
