Detecto APEX Series User Manual

3300-0188-0M Rev L y apex Digital Scale Owner’s 9
WEIGHING UNITS SELECTION
NOTE: The following instructions apply to all models of the apex® Digital
Clinical Scale, the apex with the Inline Height Rod, and the apex-sh with the
Sonar Height Rod.
Whe
n the scale is turned on for the first time, it will display a prompt to select the weighing
units to use for your operation, lb (pounds) or kg (kilograms). The weighing units selection can
ONLY be made at this time and cannot be changed afterward. Make sure you select the
correct weighing units before proceeding.
1.
Pr
ess
key to turn scale on.
2. A display test will be performed (all digits on the weight display will turn on), then change
to show the software version for a few seconds, and finally the display will change to
show :! '")& with the lb annunciator (factory units setting) turned on
.
3.
If the lb (pounds) units setting is acceptable, press the
key to save it, and then
pr
oceed to step 5.
4.
Other
wise, press the
× or Ø keys to toggle the weighing units from lb (pounds) to kg
(kilograms), and then press the key to save it.
5. The display will change to show ., with the Æ0Å (ZERO), the [\ (STABLE) and th
e
kg
annunciator will be turned on.
6. The scale is now ready for operation.
PLACING THE SCALE
x For indoor use only.
x Place the scale on a flat, level floor or low-cut carpet away from heating and cooling vents.
x Make certain the AC Power Adapter (if included) cord is out of the way of normal traffic to
avoid a trip hazard.
x NEVER allow the scale to get wet.
Check to make certain the scale is level. The level indicator is
located at the rear of the scale. If the scale is not level (the bubble
will not be centered), position the scale as required to center the
bubble and attain a level scale.
NOTE: Any time the scale is moved or re-located, be sure to check the level
bubble to ensure
the scale is level before using.
NOT LEVEL LEVEL
IMPORTANT! Make sure you select the
correct weighing units. Once the weighing
units has been set, it cannot be changed.

Detecto APEX Series Specifications

General

Brand	Detecto
Model	APEX Series
Category	Scales
Language	English