Configuring printer driver settings
5
ineo 160 5-11
How to create a new watermark
1 To create a new watermark, type the desired text in the box.
2 Click the [New] button.
2
Note
Watermark text can be up to 20 characters long.
You can have up to 31 different watermarks configured at one time. (in-
cluding “<None>”)
Delete
Click this button to delete the watermark that is selected in the list.
Shading
Specify a relative density for the watermark text between 10 % and 100 %.
Style
Use these check boxes to turn bold style and italic style on (check box se-
lected) or off (check box cleared).
Font
Use the settings in this group box to specify the typeface and the point size
of the watermark text.
Type Face: You can specify any of the typefaces currently installed on your
computer’s operating system as the typeface of the watermark text.
Size: Specify text size between 8 and 200 points.
Angle
Use this setting to specify the angle of the watermark text relative to the pa-
per. The setting range is -90° to +90°.
A negative (-) value rotates the characters clockwise, 0 specifies the text
should be parallel to the paper, and a positive (+) value rotates the characters
counterclockwise.
To Next Page
Loading...
