Develop ineo+ 454 - Forward Tx Setting; Report Settings

7
7-28 ineo+ 224/284/364/454/554
[Forward TX Setting]
To display: [Utility] - [Administrator Settings] - [Fax Settings] - [Function Settings] - [Forward TX Setting]
Configure the settings for using the Forward TX function.
Forward TX is a function that transfers a received fax to a pre-specified destination.
[Report Settings]
To display: [Utility] - [Administrator Settings] - [Fax Settings] - [Report Settings]
Specify the conditions for printing fax-related reports.
Settings Description
[Yes]/[No] Select whether to use Forward TX.
[No] is specified by default.
[Output Method] Select whether to print a received fax on this machine when forwarding it.
• [Forward & Print]: Prints a received fax on this machine when forward-
ing it.
• [Forward & Print (If TX Fails)]: Prints a received fax on this machine only
when forwarding has failed.
[Forward & Print (If TX Fails)] is specified by default.
[Forward Dest.] Specify a destination where to forward a received fax.
Directly enter the appropriate fax number using the Keypad, or tap [Select
from Address Book] and select one of the destinations registered on this
machine.
You can specify [File Type] and convert a fax into a file except when the
destination is a fax machine.
[Select Line] If two lines are used, select the line used to send a fax. If [No Selection] is
selected, either line, whichever is not busy, is used for transmission.
[No Selection] is selected by default.
Settings Description
[Activity Report] Set the printing conditions for a report containing results of faxes sent and
received.
For details, refer to page 7-29.
[TX Result Report] Select when to print a report containing the results of fax transmission.
For details, refer to page 7-29.
[Sequential TX Report] Select whether to print a report containing results of faxes sent by polling
and broadcast.
For details, refer to page 7-30.
[Timer Reservation TX Re-
port]
Select whether to print a report when transmission is reserved using the
Timer TX function.
For details, refer to [User's Guide: Fax Operations].
[Confidential Rx Report] Select whether to print a report containing the results of confidential faxes
received.
For details, refer to [User's Guide: Fax Operations].
[Bulletin TX Report] Select whether to print a report containing records of faxes registered with
the bulletin for being received by polling.
For details, refer to [User's Guide: Fax Operations].
[Relay TX Result Report] Select whether to print a report containing results of faxes sent by relay
distribution.
For details, refer to [User's Guide: Fax Operations].
[Relay Request Report] Select whether to print the report when the machine has received a fax (Re-
lay RX) as a relaying station.
For details, refer to [User's Guide: Fax Operations].
[PC-Fax TX Error Report] Select whether to print a report if PC-Fax TX using the fax driver has failed.
For details, refer to [User's Guide: Fax Operations].
[Broadcast Result Report] Select whether to combine results of broadcast on all destinations involved
or list them for each destination.
For details, refer to page 7-30.