ConnectCore for i.MX51
©2011DigiInternational,Inc. 15
18 - GND - -
19 WLAN WLAN_TDO WLAN: TDO Not Used
20 WLAN WLAN_TCK WLAN: TCK Not Used
21 WLAN WLAN_TDI WLAN: TDI Not Used
22 WLAN WLAN_TMS WLAN: TMS Not Used
23 WLAN WLAN_LED WLAN: LED_ON WLAN LED
24 WLAN RS_BT_PRIORITY WLAN: BT_PRIORITY Not Used
25 WLAN RS_WLAN_ACTIVE WLAN: WLAN_ACTIVE Not Used
26 WLAN RS_BT_ACTIVE WLAN: BT_ACTIVE Not Used
27 LVIO BOOT_MODE0 i.MX51: BOOT_MODE0 Boot Mode selection Boot configuration not
available in EA Kit
28 GPIO33 WLAN_DISABLE# WLAN Power Supply Switch WLAN Disable Jumper (J17) This signal switch ON/OFF
the supply of WLAN
29 LVIO BOOT_MODE1 i.MX51: BOOT_MODE1 Boot Mode selection Boot configuration not
available in EA Kit
30 - VLIO MC13892: BATT Battery supply
31 - VLIO MC13892: BATT Battery supply
32 - VCHRG MC13892: CHRGRAW Charger supply
33 - +2.775V - -
34 - VCHRG MC13892: CHRGRAW Charger supply
35 - +2.775V - -
36 - +2.775V - -
37 PMIC_GPO MC13892_GPO1 MC13892: GPO1 Reserved
38 - +2.775V - -
39 PMIC_PWRON PMIC_PWRON1 MC13892: PWRON1 Connected to Power Button (S11) Suspend / Wake-up button
40 PMIC_STDBY PMIC_STDBY_REQ i.MX51: PMIC_STBY_REQ
MC13892: STANDBY
Reserved Output from i.MX51 to put
MC13892 in low power
mode
41 PMIC_INT PMIC_INT_REQ i.MX51: PMIC_INT_REQ Reserved This high-priority interrupt
input on i.MX51 is not used.
The output interrupt from
PMIC is connected to
standard interrupt GPIO_5 on
i.MX51.
42 PMIC_PWGTDRV PWRGTDRV1 MC13892: PWRGTDRV1 Not used
43 PMIC_LED CHRGLED MC13892: CHRGLED Battery Charging LED
Pin I/O Type Signal name Use on module Use on development board Comments
To Next Page
Loading...
Need help?
General
