Using the command-line interface Connect to the TransPort router from a PC
Digi TransPort® Routers User Guide
122
Connect to the TransPort router from a PC
If you configured the router by using the Getting Started Wizard at setup time, following instructions
in the Quick Start Guide for your product, your router is already configured.
Command line
1. Verify that the router is connected to a PC.
2. Verify that terminal emulation software, such as TeraTerm or HyperTerminal, is installed on
the PC.
3. Configure your terminal emulation software:
n COM Port: select the appropriate port, typically COM1
n Baud Rate: 115200
n Data Bits: 8
n Stop Bits: 1
n Parity: No
n Parity: No Parity
n Flow Control: None
4. Verify that the connection is active by typing at (in upper or lower case) and pressing ENTER. If
the device is functioning properly, it will return the response OK. To learn more about the AT
commands, see AT commands.
5. Verify that the COM port is configured correctly by typing ati5 and pressing ENTER.
To Next Page
Loading...
