Digi TransPort WR21 - Configure PPP Negotiation

Configuring network interfaces Configure PPP and external modems
Digi TransPort® Routers User Guide
386
Configure PPP negotiation
When PPP starts up, the devices at both ends of the link negotiate the link parameters to find a
common subset that both devices can use. The negotiation may be summarized by saying that both
ends send negotiation packets with the following message:
These are the values that I wish to use, and these are the values that I wish you to use.
ÉWeb
1. Go to Configuration >Network >Interfaces >Advanced >PPP0 - 9 >PPP n >
PPPNegotiation.
2. Configure PPP negotiation parameters as needed:
Restrict the negotiation time to s seconds
The maximum time allowed for a PPP negotiation to complete. If negotiations have not
completed in this time, the PPP instance is disconnected.
Disconnect if the remote requests an IP address
Disconnects the PPP link if the remote host requests an IPaddress from the router.
Desired local ACCM
The local Asynchronous Control Character Map which has the default value 0x00000000.
Changing this value is for advanced users.
Desired remote ACCM
The remote ACCM which has the default value 0xffffffff. As above, the default will work in
nearly all circumstances and should be changed only where really necessary.