Using the command-line interface Application commands
Digi TransPort® Routers User Guide
138
config command: show/save configuration
The config command shows the current or stored configuration settings, saves the current
configuration, and specifies which configuration to use when powering up or rebooting the router. The
format of the config command is:
conf i g <0| 1| c> <save| show| power up>
You can store two separate configurations, numbered 0 and 1. The first parameter of the config
command specifies to which configuration the command applies. The letter c indicates the current
configuration settings, such as those currently in use.
The second parameter is one of the following keywords:
n show displays the specified configuration (either 0, 1 or c for the current configuration).
n save saves the current settings as the specified configuration (either 0 or 1).
n powerup sets the specified configuration (either 0 or 1) to use at power-up or reboot.
For example, to display the current configuration, type:
conf i g c show
The output is similar to the following:
conf i g c show
et h 0 descr " LAN 0"
et h 0 I Paddr " 192. 168. 1. 1"
et h 0 mask " 255. 255. 255. 0"
et h 0 br i dge ON
et h 1 descr " LAN 1"
et h 2 descr " LAN 2"
et h 3 descr " LAN 3"
et h 4 descr " ATM PVC 0"
The configuration files only contain details of those settings that are different from the router’s
default settings. If you configure a setting that is the same as the default setting, it does not appear in
a stored configuration.
To save the current settings to configuration file 1, type:
conf i g 1 save
To use configuration file 1 when the powering up or rebooting the router, type:
conf i g 1 power up
To Next Page
Loading...
