Digi TransPort WR21 - Configure Basic Ethernet IP Address Parameters

Configuring network interfaces Configure Ethernet interfaces
Digi TransPort® Routers User Guide
180
Configure basic Ethernet IP address parameters
Note To configure the Ethernet interface to support IPv6 addressing, see Configure IPv6 addressing
support.
ÉWeb
1. Go to Configuration > Network > Interfaces >Ethernet>ETH n.
The Configuration > Network > Interfaces >Ethernet>ETH n initial view only shows basic IP
address parameters. The choice is to obtain an IP address by using a DHCP server or to
manually configure the IP addressing for this interface.
2. Configure basic Ethernet IP address settings:
Description
Use a memorable name for this Ethernet instance, to make it easier to identify.
Get an IP address automatically using DHCP
Enables the DHCP client on this interface. You can elect to override the DHCP server settings
for the Mask, Gateway, DNS Server, and Secondary DNS Server.
Use the following settings
Enables manual configuration of the IP addressing parameters
IP Address
Specifies the IP address of this Ethernet port on your LAN.
Mask
The subnet mask of the IP subnet to which the router is attached via this Ethernet port.
Typically, this would be 255.255.255.0 for a Class C network.
Gateway
The IP address of a gateway the router uses. IP packets whose destination IP addresses are
not on the LAN to which the router is connected are forwarded to this gateway.