Digi TransPort WR21 - Ntpstat Command: Check NTP Client Status

Configuring system settings Set system date and time
Digi TransPort® Routers User Guide
720
Command Instance Parameter Values
Equivalent web
parameter
ntp n bcast3 0, 1
0=disabled
1=enabled
Broadcast Mode
ntp n minpoll 3-14 Poll Interval s1, s2
See minpoll parameter for
values.
ntp n maxpoll 3-14 Poll Interval s1, s2
See minpoll parameter for
values.
ntp n burstint3 0-255 Startup burst Interval s
seconds
ntp n server4 Valid IP address or hostname,
such as ntp4.timeserver.org
NTP Server.
ntp n bcast4 0, 1
0=disabled
1=enabled
Broadcast Mode
ntp n minpoll4 3-14 Poll Interval s1, s2
See minpoll parameter for
values.
ntp n maxpoll4 3-14 Poll Interval s1, s2
See minpoll parameter for
values.
ntp n burstint4 0-255 Startup burst Interval s
seconds
ntpstat command: Check NTP client status
To check the status of the NTP client, use the ntpstat command. See the Command line section of
Show NTP status.