Digi TransPort WR21 - At\Smib Commands

Using the command-line interface AT commands
Digi TransPort® Routers User Guide
168
at\smib commands
The at\smib command allows you to view a single standard MIB variable. For more information on
MIBs and SNMP, see Use SNMP for remote management.
To view the MIB variable, use the at\smib=mib_name command, where mib_name is the variable to
be displayed. The variables are sorted according to the hierarchy shown below.
Commands for displaying system information
The system hierarchy consists of the following:
at\smib=mib-2.system.sysdescr: Show software version information
Shows the software version information; equivalent to what is shown on the ati5 CLI command
output.