Digi TransPort WR21 - Page 191

Configuring network interfaces Configure Ethernet interfaces
Digi TransPort® Routers User Guide
191
Command Instance Parameter Values Equivalent web parameter
eth n mhome 0-255 Multihome additional consecutive
addresses
eth n igmp 0, 1 Enable IGMP on this interface
eth n bridge 0, 1 Enable Bridge on this interface
eth n heartbeatip IP address Send Heartbeat messages to IP address
a.b.c.d every h hrs m mins s seconds
eth n hrtbeatint 0-86400 Send Heartbeat messages to IP address
a.b.c.d every h hrs m mins s seconds
This CLI value is entered in seconds only.
eth n hbipent blank, eth, ppp Use interface x,y for the source IP
address
x=Interface type
eth n hbipadd 0-255 Use interface x,y for the source IP
address
y=interface number
eth n hbroute 0, 1 Select the transmit interface using the
routing table
eth n hbimsi 0, 1 Include IMSI information in the
Heartbeat message