Digi TransPort WR21 - Page 220

Configuring network interfaces Configure Wi-Fi interfaces
Digi TransPort® Routers User Guide
220
Note The roam_threshold and roam_timeout parameters can impact monitoring. If roam_threshold
and roam_timeout are both non-zero, and the Wi-Fi node is configured in client mode, monitoring of
the signal strength of the link to the currently associated Access Point starts as soon as the client has
successfully connected to that Access Point. Signal strength monitoring stops at any time the client
disconnects from the Access Point. If the RSSI of frames received from the Access Point stays below
the roam_threshold for roam_timeout consecutive seconds, monitoring stops and the client starts
scanning for Access Points.
Wi-Fi node security settings
Command Instance Parameter Values Equivalent web parameter
wifinode 0 security none
wep
wpapsk
wpa2psk
wparadius
wpa2radius
Use the following security on this
Wi-Fi interface
wifinode 0 weptype open,
sharedkey
Not available on the WEB.
wifinode 0 wepkeylen 64, 128 WEP Key size
wifinode 0 wepkeyindex 1-4 WEP Key index
wifinode 0 wpatype tkip, aes WPA Encryption
wifinode 0 sharedkey text WEP Key/WPA pre-shared key
radcli n* nasid String RADIUS NAS ID
radcli n* server IP Address RADIUS Server IP Address
radcli n* password String RADIUS Server Password
* The Wi-Fi interfaces each use a fixed RADIUS client. For example:
n Wi-Fi 0 uses radcli 1
n Wi-Fi 1 uses radcli 2
n Wi-Fi 2 uses radcli 3, and so on.
The following table details the authentication and encryption algorithms and the CLI commands
needed to configure them.
Network Authentication Data Encryption CLI Commands
Open Disabled wifinode 0 security none
Shared Disabled Not supported