Digi TransPort WR21 - Page 300

Configuring network interfaces Configure PSTN interfaces
Digi TransPort® Routers User Guide
300
Reset the data limit on the n day of the month
The day of the month on which the data limit is reset to 0.
3. Click Apply.
Command line
Command Instance Parameter Values Equivalent web parameter
ppp n metric 0-255 Metric
ppp n aodion 0-2
0=disabled
1=enabled
2=On and return
to service
immediately
Enable “Always On” mode of this
interface, On, On and return to
service immediately
ppp n immoos on, off Put this interface “Out of
Service” when an always-on
connection attempt fails
ppp n aodi_dly 0-2147483647 Attempt to reconnect after s
seconds
ppp n aodi_dly2 0-2147483647 If an inhibited PPP interface is
connected, attempt to re-
connect after s seconds
ppp n pwr_dly 0-2147483647 Wait s seconds after power-up
before activating this interface
ppp n tband 0-4 Control when this interface can
connect using Time Band n
ppp n minup 0-2147483647 Keep this interface up for at
least s seconds
ppp n maxup 0-2147483647 Close this interface after s
seconds
ppp n maxuptime 0-2147483647 if it has been up for m minutes in
a day
ppp n timeout 0-2147483648 if the link has been idle for s
seconds
ppp n timeout2 0-2147483648 Alternative idle timer for static
routes s seconds
ppp n rxtimeout 0-2147483648 if the link has not received any
packets for s seconds
ppp n maxneg 0-2147483648 if the negotiation is not
complete in s seconds