Digi TransPort WR21 - Page 305

Configuring network interfaces Configure DialServ interfaces
Digi TransPort® Routers User Guide
305
Keep Security Associations (SAs) when this PSTN interface is disconnected
When enabled, causes the router to maintain (such as not flush) the SA when the interface
becomes disconnected. The normal behavior is to remove the SAs when the interface becomes
disconnected.
Use interface x,y for the source IP address of IPsec packets
If it is required to use another interface (such as not the interface currently being configured)
as the source address for IPsec packets, this may be achieved by selecting the desired
interface from the drop-down list and typing the desired interface instance number into the
adjacent text box.
Enable the firewall on this interface
When enabled, applies the firewall rules to traffic using this interface.
3. Click Apply.
Command line
Command Instance Parameter Values
Equivalent web
parameter
ppp n name Up to 25
characters
Description
ppp n phonenum up to 25 digits Dial out using numbers
ppp n ph2 “ Dial out using numbers
ppp n ph3 “ Dial out using numbers
ppp n ph4 “ Dial out using numbers
ppp n prefix 0-9999999999 Prefix
ppp n username Up to 60
characters
Username
ppp n password Up to 40
characters
Password
ppp n IPaddr 0.0.0.0 Allow the remote device
to assign a local IP
address to this router
ppp n IPaddr Valid IP address
a.b.c.d
Try to negotiate a.b.c.d
as the local IP address
for this router
(in conjunction with l_
addr)