Digi TransPort WR21 - Page 327

Configuring network interfaces Configure serial interfaces
Digi TransPort® Routers User Guide
327
Disable command echo
When enabled, disables command echo for the TransIP port. When disabled, all commands
issued are echoed back to the TransIP TCP socket.
Escape char c
The ASCII character to use as the escape character. The default character is +. Entering this
escape character three times followed by a pause of at least the Escape delay parameter and
an AT command causes the router to switch back to command mode from online mode. This is
equivalent to the S2 register setting.
Escape delay s milliseconds
The delay required between entering the escape sequence (default +++) and the AT command
for the router to drop back into command mode. This is equivalent to the S12 register setting.
3. Click Apply.
Command line
Command Instance Parameter Values
Equivalent web
parameter
transip n port Valid port number 0-
65535
Listen on port
transip n host Valid IP address a.b.c.d
or hostname
Connect to IPaddress
a.b.c.d or Hostname
transip n remport Valid port number 0-
65535
Port
transip n keepact 0-255 Send TCP Keep-Alives
every s seconds
transip n staycon on, off Enable Stay Connected
mode
transip n cmd_echo_
off
on, off Disable command echo
transip n escchar Valid ASCII character Escape char c
transip n esctime 0-255 Escape delay s
milliseconds