Digi TransPort WR21 - Page 619

Configuring legacy protocols Configure X.25 parameters
Digi TransPort® Routers User Guide
619
Virtual ASY port
The virtual ASY port number that this LAPB instance will multiplex over the physical port.
3. Click Apply.
Command line
Command Instance Parameter Values Equivalent web parameter
lapb n l1iface port, isdn
(use port for
sync port)
Use: Serial port Port x (in Synchronous
Mode)
lapb n l1nb 0, 1 Use: Serial port Port x (in Synchronous
Mode)
0 for Port 0, 1 for Port 1
lapb n l1iface port, isdn
(use isdn for
ISDN)
Use: ISDN
lapb n dtemode DTE/DCE
mode:
0=DTE
1=DCE
Mode DTE or DCE
lapb n N400 1-255 N400 Counter x
lapb n tnoact 1000-60000 RR Timer x milliseconds
lapb n t1time 1-60000 T1 Timer x milliseconds
lapb n t200 1-60000 T200 Timer x milliseconds
lapb n Window 1-7 X.25 Window Size
lapb n tinactx25 0-3000 Disconnect link if there has been no X.25
activity for x seconds
lapb n tinact 0-3000 Disconnect link if there has been no
activity for x seconds
lapb n restartact 1=enabled
0=disabled
Send X.25 Restart packet on receipt of
SABM frame
lapb n ans 1=enabled
0=disabled
Allow this unit to answer calls
lapb n msn text Only accept calls from calling number
ending with
lapb n sub text Only accept calls with sub-address
ending with