Digi TransPort WR21 - Page 636

Configuring legacy protocols Configure X.25 parameters
Digi TransPort® Routers User Guide
636
Command Instance Parameter Values Equivalent web parameter
pad n buipaddr text Remote IP Address when using the
backup interface
pad n ip_port 0-65535 IP Stream port
pad n iphdr 0=Off
1=On
2=8583 Ascii 4 byte
IP length header
pad n prompt text PAD prompt
pad n padmode 0=Normal
1=Prompt Always On
PAD mode
pad n profile 1-4, 50, 51,90,91 Use PAD Profile
pad n strip_
tspaces
1=enabled
0=disabled
Strip Trailing Spaces
pad n llmode 1=enabled
0=disabled
Enable Leased Line Mode
pad n enqcon 1=enabled
0=disabled
Send ENQ on Connect
pad n stxmode 1=enabled
0=disabled
Enable STX / ETX Filtering
pad n delconmsg 0-10 Delay connect message n x 10
milliseconds
pad n data_del 0-2147483647 Delay data transfer after connection by
n x 10 milliseconds
pad n inacttim 0-1000 Terminate the PAD call after x seconds
if there has been no data transmission
pad n nocalltim 0-60000 Disconnect the layer 2 call if there is no
layer 3 call in progress for x seconds
pad n trig_str text Create an event when the following
data is on the PAD
pad n inactevent 0-2147483647 Create an event when there has been
no activity on the PAD for x seconds
Stopping and starting PADs
To stop and start PAD instances, use the following CLI commands:
n stoppads: Stops all PAD instances from accepting and performing any PAD commands.
n gopads: Resumes processing of PAD commands.
The stoppads and gopads commands can have the PAD number specified in the syntax to stop and
start individual PAD instances.
For example: