Digi TransPort WR21 - Page 649

Configuring legacy protocols Configure X.25 parameters
Digi TransPort® Routers User Guide
649
Command Description
CALL Make an X.25 call.
CLR Clear an X.25 call.
ICLR Invitation to CLR.
INPAR? List X.3 parameters of specified PAD instance.
INPROF Load or save specified PAD profile.
INSET Set X.3 parameters of specified PAD instance.
INT Send Interrupt packet.
LOG Log off and disconnect.
PAR? List local X.3 parameters.
PROF Load or save PAD profile.
RESET Send reset packet.
RPAR? List remote X.3 parameters.
RSET Set remote X.3 parameters.
SET Set local X.3 parameters.
STAT Display channel status.
CALL command: Make an X.25 call
The full structure of a CALL command is:
CALL [ <f aci l i t i es- >] <addr ess>[ D<user dat a>]
where:
n <facilities-> is an optional list of codes indicating the facilities to be requested in the call
(separated by commas, terminated with a dash)
n <address> is the destination network address.
n <user data> is any optional user data to be included with the call.
The facility codes supported are:
n F: Fast select-no restriction
n Q: Fast select-restricted response
n Gnn: Closed User Group
n Gnnnn: Extended Closed User Group
n R: Reverse charging
n N<NUI>:Network User Identity code (NUI)
Example
The following command places a call to address 56512120 using reverse charging and specifying
Closed User Group 12. The string MYNUI is your Network User Identity. The string Hello appears in