Digi TransPort WR21 - Page 655

Configuring legacy protocols Configure X.25 parameters
Digi TransPort® Routers User Guide
655
where nn is the number of the User PAD profile to store, such as 03. Alternatively, you can use the
web interface to edit the parameters directly (Configuration > Network > Legacy Protocols > X.25
> PADs n-n > PAD n > PAD Settings).
The pre-defined profiles (50, 51, 90, 91), cannot be overwritten and are permanently configured as
shown in the following table:
Parameter
Profile
50 51 90 91
1 1 0 1 0
2 0 0 1 0
3 0 0 126 0
4 5 5 0 20
5 0 3 1 0
6 5 5 1 0
7 0 8 2 2
8 0 0 0 0
9 0 0 0 0
10 0 0 0 0
11 15 15 15 15
12 0 3 1 0
13 0 0 0 0
14 0 0 0 0
15 0 0 0 0
16 8 8 127 127
17 24 24 24 24
18 18 18 18 18
19 2 2 1 1
20 64 64 0 0
21 0 0 0 0
22 0 0 0 0
Stored X.25 PAD profiles are held in non-volatile memory, and are not lost when the router is switched
off. When in the following format, the PROF command loads the stored profile specified by nn:
pr of nn