Digi TransPort WR21 - Page 753

Configuring security Configure system security settings
Digi TransPort® Routers User Guide
753
Allow autoexec.bat files to run from Mass Storage Devices
Enables/disables running the autoexec.bat files from the mass storage devices. For additional
details on running autoexec.bat files from mass storage devices, see Manage files using USB
storage devices.
Enable “Factory Default” reset button
Enables/disables execution of a complete hardware reset.
3. Click Apply.
Command line
Command Instance Parameter Values
Equivalent web
parameter
cmd 0 encpasswords
on, off
Default is off
Enable password
encryption
usbcon 0 dislist
list of USB ports,
where:
x=1 for the bottom
USB port and 2 for
the top port.
p=<port #> (if
connected to a USB
hub the port numbers
can increase).
DRIVER=MSD for Mass
Storage Device,
SERIAL for serial
devices, or HUB for
hub devices.
Disable the following USB
devices
usbcon 0 batfile on, off Allow autoexec.bat files to
run from Mass Storage
Devices
cmd 0 pbreset on, off Enable “Factory Default”
reset button