Page 16
4 DISPLAY
4.1 MAIN DISPLAY SCREENS
The are 3 main display screens on the Digifly instrument:
- The Thermal Display , the Glide Compass Display and the Glide Plotter Display.
To manually switch between these 3 main display screens, press the
key.
THERMAL DISPLAY
GLIDE COMPASS DISPLAY
GLIDE PLOTTER DISPLAY
4.2 AUTOMATIC SCREEN SWITCHING - INTELLIFLIGHT
The Intelliflight function handles the automatic screen
switching between the Thermal Display screen and Glide
Compass Display or Glide Plotter Display screens.
To enable this function go to (ADVANCED SETUP \ n. 1 IFLY)
and set it to “ON”.
The Digifly instrument will switch automatically to the
Thermal Display screen when the conditions of a thermal are
met.
To set the thermal detection parameters, go to (ADVANCED
SETUP \ n. 2 THEV) and (ADVANCED SETUP \ n. 3 THET) to adjust the vertical speed
(vario) and for how many consecutive seconds this vertical speed has to be detected.
The instrument will then switch back to the Glide Compass or Glide Plotter display
screens when there is no lift for more than 10 seconds.
To Next Page
Loading...
Need help?
General
