Page 67
10.9 MAIN SETUP PARAMETERS
The following is a list of parameters that can be adjusted. For each parameter you can see the
range of values, the factory setting (default) and the unit of measure.
n Name Description Range Default Units
1 CTRS display contrast 40 - 60 50 %
2 V.UP acoustic vario lift setting 0 - 25 0.05 m/s
3 V.DN acoustic vario sink setting 0 - 25 3.5 m/s
4 TONE vario tone FAS/STD/SFT STD ----
5 RVAR acoustic vario sensitivity 0.1- 3.0 0.4 sec
6 INTE vario integrator 0 - 60 1 sec
7 FS_V graphic vario scale (1,6,12) LOW/MED/HIGH MED m/s
8 SIMV vario simulator ON/OFF OFF ----
9 STAL stall alarm level 0 - 150 0 km/h
10 TEC total energy compensation 0 - 100 0 %
11 KIAS air speed calibration 50 - 200 100 %
12 KBAR barometer calibration +/- 20.0 0 mB
13 BARX graphic altimeter x 0.4 - 4 1.0 min
14 BARY graphic altimeter y 3 - 3000 30 mt
15 UTCO time zone difference -12/+12 2 hour
16 HOUR time setting: hours 0 - 23 ---- hour
17 MIN time setting: minutes 0 - 59 ---- minute
18 DAY time setting: day 1 – 31 ---- day
19 MONT time setting: month 1 – 12 ---- month
20 YEAR time setting: year 0 – 99 ---- year
21 PILO pilot name 6 letters ---- ----
22 RECM recorder mode AUT/ALW/OFF AUT ----
23 R.DS autorecorder meters 1 – 30 2 ----
24 RECR recorder rate 1 - 60 3 sec
25 RECA recorded altimeter GPS/BAR GPS ----
26 GTYP glider type 6 letters ---- ----
27 GID glider id 6 letters ---- ----
28 U-AL altimeter units MT/FT MT ----
29 U-SP speed units KMH/MPH KMH ----
30 U-TE temperature units °C/°F °C ----
31 KTMP temperature calibration +/- 20.0 0 °C
32 LANG help language USR/UK/ITA/ESP/DEU/FRA/CZE/HUN/LN1/LN2
To Next Page
Loading...
Need help?
General
