DG-BG1000 User Manual
26
The following table describes the parameters in this page:
Parameter Description
Obtain an IP address
automatically
Select it, DHCP automatically assigns the IP
address for WAN connection.
Use the following IP
address
Select it, you need to manually enter the IP
address, subnet mask, and default gateway
for WAN connection, which are provided by
your ISP.
Obtain DNS server
addresses automatically
Select it, DHCP automatically assigns DNS
server address.
Use the following DNS
server addresses
Select it, you need to manually enter the
primary DNS server address and secondary
DNS server address.
Enable NAT
Select it to enable network address
translation (NAT). If you do not select it and
you want to access the Internet normally,
you must add a route on the uplink
equipment. Otherwise, the access to the
Internet fails. Normally, it is required to
enable NAT.
Note:
If the WAN connection type is set to 1483 Routed, the parameters of the WAN
connection type are the same as that of 1483 MER. For the parameters in these
pages, refer to the parameter description of 1483 MER.
To Next Page
Loading...
