DG-BG1000 User Manual
65
3.6 Advance
In the navigation bar, click Advance. In the Advance page that is displayed
contains Bridge Setting, Routing, QoS, SNMP and Others.
3.6.1 Bridge Setting
Choose Advance > Bridge Setting, the page shown in the following figure
appears. This page is used to configure the bridge parameters. You can change the
settings or view some information on the bridge and its attached ports.
The following table describes the parameters and button of this page:
Parameter Description
Aging Time If the host is idle for 300 seconds (default value), its
entry is deleted from the bridge table.
802.1d Spanning
Tree
You can select Disabled or Enabled.
Select Enabled to provide path redundancy while
preventing undesirable loops in your network.
Show MACs Click it to show a list of the learned MAC addresses
for the bridge.
To Next Page
Loading...
Need help?
General
