Digisol DG-BG100 User Manual

DG-BG1000 User Manual
72
3.6.4 SNMP
Choose Advance > SNMP, the page shown in the following figure appears. You
can configure the SNMP parameters.
The following table describes the parameters of this page:
Parameter
Description
Enable SNMP
Select it to enable SNMP function. You need to
enable SNMP, and then you can configure the
parameters of this page.
Trap IP Address
Enter the trap IP address. The trap information is
sent to the corresponding host.
Community name
(Read-only)
The network administrators must use this password
to read the information of this router.
Community name
(Read-Write)
The network administrators must use this password
to configure the information of the router.

Digisol DG-BG100 Specifications

General

Brand	Digisol
Model	DG-BG100
Category	Network Router
Language	English