Digisol DG-BG100 User Manual

DG-BG1000 User Manual
61
Parameter Description
updates.
Periodic Inform
Interval
Specify the amount of time between
connections to ACS.
Connection Request
User Name The connection user name provided by TR-069
service.
Password The connection password provided by TR-069
service.
Debug
Show Message Select Enable to display ACS SOAP messages
on the serial console.
CPE sends GetRPC Select Enable, the router contacts the ACS to
obtain configuration updates.
Skip MReboot Specify whether to send an MReboot event
code in the inform message.
Delay Specify whether to start the TR-069 program
after a short delay.
Auto-Execution Specify whether to automatically start the
TR-069 after the router is powered on.
3.5.6 ACL
Choose Service > ACL, the page shown in the following figure appears. In this
page, you can permit the data packets from LAN or WAN to access the router. You
can configure the IP address for Access Control List (ACL). If ACL is enabled, only
the effective IP address in the ACL can access the router.

Digisol DG-BG100 Specifications

General

Brand	Digisol
Model	DG-BG100
Category	Network Router
Language	English