DG-WA30002NP User Manual
46
select 2.4GHz (B+G), then only wireless clients using
you want to allow 802.11b, 802.11g, and 802.11n clients
If you
802.11b and 802.11g band will be able to connect to this
Access Point.
If
to connect to this Access Point, select 2.4GHz (B+G+N).
Channel nel
Number
Please select a channel number you wish to use. This chan
number must be same as the other wireless Access Point you
wish to connect.
MAC address 1 MAC address of the wireless Access Point Please input the
you wish to connect.
Set Security select an encryption mode for this Click this button to
wireless link, a new popup window will appear, as shown
below. For detailed description of encryption modes please
refer to Section
2-7
fter you finish with setting, please click ‘Apply’, and the following message A
will be displayed:
hen you see this message, the settings you made are successfully saved. W
You can click on ‘Continue’ button to go back to previous page and continue
with other settings, or click ‘Apply’ button to restart the wireless Access Point
and the changes will take effect after about 30 seconds
To Next Page
Loading...
Need help?
General
