DG-WA30002NP User Manual
Setting page.
Close Click this button to close this pop up window.
2-4-3 AP Bridge-Point to Point Mode
In this mode, this wireless Access Point will connect to another wireless
Access Point which uses the same mode, and all wired Ethernet clients of
both wireless Access Points will be connected together. You can use this
mode to connect a network to another network which is physically isolated.
Please note that when you set your Access Point to this mode, it will not
accept regular wireless clients anymore.
When you select ‘AP Bridge-Point to Point’, the following options will be
displayed:
Here is the description of every setup item:
Parameter Description
Band Please select the wireless band you wish to use. By selecting
different band settings, you’ll be able to allow or deny the
wireless client of a certain band.
If you select 2.4GHz (B), 2.4GHz (N), or 2.4GHz (G), only
wireless clients using the wireless band you select (802.11b,
802.11n or 802.11g) will be able to connect to this Access
Point.
45
To Next Page
Loading...
Need help?
General
