DG-WA30002NP User Manual
If you select 2.4GHz (B+G), then only wireless clients using
802.11b and 802.11g band will be able to connect to this
Access Point.
If you want to allow 802.11b, 802.11g, and 802.11n clients to
connect to this Access Point, select 2.4GHz (B+G+N).
Channel
Number
Please select a channel number you wish to use. This channel
number must be same as the other wireless Access Point you
wish to connect.
MAC
address 1-4
Please input the MAC address of the wireless Access Point
you wish to connect.
Set Security Click this button to select an encryption mode for this
wireless link, a new popup window will appear, as shown
below. For detail description of encryption modes please refer
to Section
2-7.
After you finish with setting, please click ‘Apply’, and the following message
will be displayed:
When you see this message, the settings you made are successfully saved.
You can click on ‘Continue’ button to go back to previous page and continue
with other settings, or click ‘Apply’ button to restart the wireless Access Point
and the changes will take effect after about 30 seconds
48
To Next Page
Loading...
