DG-WA30002NP User Manual
802.11b and 802.11g band will be able to connect to this
Access Point.
If you want to allow 802.11b, 802.11g, and 802.11n clients to
connect to this Access Point, select 2.4GHz (B+G+N).
MAIN
ESSID
Please input the ESSID (the name used to identify this
wireless Access Point) here. You can input up to 32
alphanumerical characters. PLEASE NOTE THAT ESSID
IS CASE SENSITIVE.
Channel
Number
Please select a channel number you wish to use. The channel
number must be same as the other wireless Access Point you
wish to connect.
Associated
Clients
Click ‘Show Active Clients’ button and a new popup window
will appear which contains the information about all wireless
clients connected to this Access Point, as shown below. You
can click ‘Refresh’ button in popup window to keep
information up-to-date.
MAC
address 1-4
Please input the MAC address of the wireless Access Point
you wish to connect.
Set Security Click this button to select an encryption mode for this
wireless link, a new popup window will appear, as shown
below. For detailed description of encryption modes please
refer to Section
2-7
50
To Next Page
Loading...
Need help?
General
