SmartSource Elite Series - Installation & Operations Guide
May 2019 8227 4907-005 Page 22 of 37
If foreign objects cannot be blown out with compressed air, you can attempt to remove them using a non-
metallic tool or probe such as the Digital Check track-cleaning tool (available from Digital Check,
www.digitalcheck.com, part number 750381907).
Do not use any metallic tool or probe, as damage to the track walls and other parts may result.
Do not use any magnetic tool, as damage to the MICR read head may result.
The track contains two powerful magnets which are located near the MICR read head, as shown.
Foreign objects such as staples and paper clips will often stick to these magnets, making them easier to
find and remove.
To Next Page
Loading...
