NCH02 User’s ManualDigital Dream Motion Controller Page -12
The following Picture 2-12 shows the definition of Servo/Stepper Ports.There are 5 axis X/Y/Z/A/B,each
axis connection is common anode.Output signal voltage is 5V.
DIR is Direction Signal Output;
PUL is Pulse Signal Output.
2.6 The Servo/Stepper Port
X Axis/COM+
X Axis/PUL-
X Axis/DIR-
Y Axis/COM+
Y Axis/PUL-
Y Axis/DIR-
Z Axis/COM+
Z Axis/PUL-
Z Axis/DIR-
A Axis/COM+
A Axis/PUL-
A Axis/DIR-
B Axis/COM+
B Axis/PUL-
B Axis/DIR-
Picture 2-12 Definition of Servo/Step Ports
Picture 2-13 The wiring method with Stepper driver
To Next Page
Loading...
