Digital Projection E-Vision Laser 8500 Series Installation And Quick Start Guide

page 70
Digital Projection E-Vision Laser 7500, 8500 & 10K Series
Operating Guide
USING THE PROJECTOR
Rev D August 2017
Network menu
• Network Mode
Choose between Projector Control and Service.
• Standby Power
If this setting is On, the LAN socket remains active when the projector is in STANDBY
mode. If the setting is Off, the LAN socket is disabled when the projector is in
STANDBY mode.
• DHCP, IP, Subnet Mask, Gateway, DNS
Set DHCP to On if the IP address is to be assigned by a DHCP server, or Off if it is to
be set here.
If DHCP is On, it will not be possible to edit IP Address, Subnet Mask, Gateway or
DNS.
If DHCP is set to Off, edit IP Address, Subnet Mask, Gateway and DNS as
required.
• MAC
This eld is read-only.
• AMX
Switch on or off.
Notes
Network
Standby Power
DHCP
Network Mode
IP
Gateway
DNS
Subnet Mask
MAC
AMX
Off
Off
Projector Control
192 . 168 . 000 . 100
000 . 000 . 000 . 000
000 . 000 . 000 . 000
255 . 255 . 255 . 000
00: 18: 27: 2d: f2: 06
Off

Digital Projection E-Vision Laser 8500 Series Specifications

General

Brand	Digital Projection
Model	E-Vision Laser 8500 Series
Category	Projector
Language	English