English
60
On the following images you can see possible indicators:
That’s the safety closure when it has been properly closed and
not opened again. The blue band at the top of the safety
closure and the pale yellow thermal strip is undamaged.
In extreme cold conditions (e.g. use of cold spray) the areas of
the blue tape will seperate from the carrier material. The warning
“STOP“ is readable.
Through extreme heat (e.g. hair dryer), the pale yellow thermal strip
turns red.
When using solvents, the blue color of the satey closure dissolves -
manipulation is immediately visible.
Please check if these indicators have been damaged or removed when you receive the
product. Contact your seller if the the security packaging have been manipulated, since
the security of the HS256 S3 cannot be guaranteed in this case.
The components are sealed with epoxy resin. In addition there is a warranty seal placed
on the opening point as seen below. This sealing is not evaluated by the BSI certification.
Additional warranty seals are inside of the HS256 S3.
To Next Page
Loading...