English
71
4) Type in your 8-digit device PIN and press “ENTER“. If the PIN was entered
correctly, the “STATUS“-LED flashes green several times and it sounds an
acousticsignal.
Note: If the Keypad and the red “ERROR“-LED flashes press the “ESC” button and start
again with the third step.
5) The lock-out mode is now activated/deactivated now. The “STATUS“-LED
illuminates red if the mode is activated and green if it is deactivated.
6) Disconnect the USB connection of the DIGITTRADE HS256 S3 to exit this feature.
Note: The activated lock-out mode is preset. In this mode do not remove the smart card
from the DIGITTRADE HS256 S3, as it can lead to data loss.
5.3 Copying the cryptographic keys
(Device PIN needed)
With this feature you can copy the cryptographic keys from one smart card to another.
For this at least two smart cards are needed: the smart card that has the cryptographic
keys that should be copied and one or more smart cards the cryptographic keys should
be copied on.
Follow these steps to copy the cryptographic keys:
1) Insert a working initialized smart card into the associated slot
(see chapter 1.4 and 3.1).
If the smart card is already initialized, the keypad illuminates. If the smart card has
already cryptographic keys that are not initialized with the HS256 S3, the red “ERROR”-
LED and the keypad iluminates. Initialize this smart card. (see chapter 5.4)
2) Press the “ADMIN“-button and then the “3“.
3) Press “ENTER“. The “STATUS“-LED flashes entered several times.
4) Type in your 8-digit device PIN and press “ENTER“. The “STATUS“-LED flashes
entered twice. Enter the 8-digit PIN from smart card A and press “ENTER“.
Note:
1. If the PIN entry was not successful, the red “ERROR“-LED flashes. Press the “ESC”
button and start again with the second step of copying the cryptographic keys.
2. The smart card A is automatically locked and rendered useless as soon as the 8-digit
PIN was entered eight times incorrectly.
To Next Page
Loading...
Need help?
General
