Digittrade HS256 S3 User Manual

English
72
5) The “STATUS“-LED flashes green several times during the DIGITTRADE HS256
S3 reads the cryptographic keys from smart card A. After this process is completed
the “STATUS“-LED illuminates green and it sounds an acoustic signal at the end.
6) Remove smart card A and insert smart card B into the smart card slot.
Make sure that the keypad iluminates.
7) Enter the 8-digit PIN for smart card B and press “ENTER“.
Note:
1. If the PIN entry was not successful, the red “ERROR“-LED flashes. Press the “ESC”
button and type in the PIN of smart card B again.
2. The smart card B is automatically locked and rendered useless as soon as the 8-digit
PIN was entered eight times incorrectly.
8) The “STATUS“-LED flashes green several times when the HS256 S3 is writing
the cryptographic keys to smart card B. If the process was successful,
the “STATUS“-LED illuminates green and it sounds an acoustic signal.
9) To describe further smartcards with these cryptographic keys disconnect the hard
drive and start again with step 1.
Note: Do not remove the smart card during the reading/writing process (steps 5 and 8,
the “STATUS“-LED flashes green several times), otherwise the mart card could be dam-
aged.

Digittrade HS256 S3 Specifications

General

Brand	Digittrade
Model	HS256 S3
Category	Storage
Language	English