General safety notes
www.dilo-gmbh.com | 0100.bae
Basic safety measures during normal operation
The equipment may only be operated throughout the EU by trained and
qualified persons who have been certified in accordance with EC 305/2008
regulations. Transition period until 30
th
June 2009.
Only trained and authorized persons who are fully aware of the operating manuals should operate the
device and should do so in accordance with the operating manuals.
Before switching on the device ensure that
only authorized persons are present at the device
nobody can be hurt by the operation of the device
Whenever the device is started check for visible damage beforehand and ensure that it is operated in the
correct conditions. Eliminate any damage immediately or inform your supervisor.
Prior to each start check and make sure that the safety features are properly set.
For concentrations of SF
6
decomposition products of > 100 ppm
v
we
recommend using a pre-filter unit to protect the device.
In case of contamination, rinse the device (for at least 10 minutes) with pure
SF
6
-gas, e. g. by circulation.
All gas compartments and vessels connected to the device via gas connecting
coupling and connecting hose must be equipped with their own safety
equipment against overpressure and vacuum.
The safety equipment integrated in the device only serves for the self-protection
of the device without consideration of the load-bearing capacity of the gas
compartment connected. In case of non-observance there is the danger of
implosion or explosion of the gas compartment if the device is not operated
correctly.
Warning
Danger
To Next Page
Loading...
