Dry-running compressor | TM 5.0 B
www.dilo-gmbh.com | C 1610-10 | Page 9 / 18
Basic safety measures during normal operation
Only trained and authorized persons who are fully aware of the operating manuals should
operate the device in accordance with the operating manuals.
Before switching on the device ensure that
only authorized persons are present at the device
nobody can be hurt by the operation of the device
Whenever the compressor is started check for visible damage beforehand and ensure that it is
operated in the correct conditions! Eliminate any damage immediately!
Basic safety measures during maintenance
Follow inspection and maintenance periods described in the operating manuals!
Follow maintenance and repair instruction for individual components in these operating
manuals!
Prior to carrying out maintenance and repair works turn off the main switch for the power
supply and secure it with a padlock. The key for this lock must be in the hands of the person
who carries out the repair works.
If there is no main switch unplug the power supply cable at the plant and secure it against being
plugged in again.
When exchanging heavy machine parts only use suitable lifting devices in good working
condition.
Prior to carrying out maintenance or repair works ensure that parts which may need to be
touched have cooled down to room temperature!
Dispose of grease, auxiliary or cleaning material in accordance with environmental regulations!
To Next Page
Loading...
