Dilo SF6 - Work on Electrical Equipment and Overpressure

Dry-running compressor | TM 5.0 B
www.dilo-gmbh.com | C 1610-10 | Page 10 / 18
Work on electrical equipment
 Only properly trained electricians should carry out repair works on the electrical equipment of the
compressor.
Regularly check the electrical equipment!
 Re-tighten loose connections!
 Replace damaged lines/cables immediately!
Works on equipment under overpressure
 Only specially trained personnel should carry out maintenance and repair works on equipment
which is under overpressure.
 Prior to maintenance and repair works depressurize the compressor equipment which is under
overpressure.
 After having carried out maintenance or repair works and prior to putting the equipment back into
service:
 check whether loosened screw connections are properly sealed
 ensure that the tank caps and components that have been removed have been re-installed!
 After having carried out the maintenance or repair works and before operation ensure that
 all materials, tools and other equipment which were necessary for the maintenance or
repair works have been removed from the working area of the compressor,
 all safety devices for the unit are properly set and in working order.
Observe environmental standards
 Whenever working on and with the compressor please observe legal requirements for waste
handling and disposal.
 Particularly during installation, repair and maintenance works substances that cause water
pollution such as
 lubricating grease
 auxiliary material
 cleansing liquors containing solvent
must not contaminate the soil or flow into drains!
These substances should be stored and transported in suitable vessels and removed and disposed
of according to local regulations!