18 www.dimplex.com
Operation
C. Heat ON/OFF
Cycles the unit sequentially
through the 3 settings: Low Heat,
High Heat and O.
→ Activated by pressing the
button on the unit or the
remote.
• Indicated by the
icon and
the intake temperature being
displayed on the On-Screen
Display, for 5 seconds before
turning off.
!
NOTE: After the heater is
switched o, there is a 60
second fan delay, where the
fan will continue running before
turning o.
!
NOTE: The unit can be
operated in Heat Only Mode.
When the unit is only running
with the heater, the
icon will
continuously be displayed on
the On-Screen Display.
!
NOTE: The heater may emit
a slight, harmless odor when
rst used. This odor is a normal
condition caused by initial
heating of internal heater parts
and will not occur again.
D & E.
Thermostat
Controls
Adjusts the temperature setpoint
to your individual requirements.
Once the desired set temperature
is reached, the heater will turn
off. The heater will cycle on
and off to maintain the desired
set temperature. The default
temperature setting is 72°F
(22°C).
→ Adjusted by pressing the
to decrease the setpoint and
the
to increase the setpoint
on the unit or the remote.
• The On-Screen Display will
indicate the temperature
setpoint as it is adjusted.
!
NOTE: Holding the
and the
buttons on the
manual controls down for
two seconds, will change the
temperature from °C to °F, or
vice versa.
To Next Page
Loading...
Need help?
General
