19
Operation
Disable Heat
If desired, depending on the
season, the heater on the unit
can be disabled. The unit will
operate in the same fashion, with
remainder of the controls.
Pressing the
and buttons
on the manual controls at the
same time and holding for 2
seconds will disable and enable
the heater.
!
NOTE: When the heater has
been disabled and either the
or the is pressed the
On-Screen Display will indicate
"--".
F. Color Themes
Dierent presets of ambient
lighting color combinations
contained in the unit.
→ Changed by repeatedly
pressing the corresponding
button on the remote or the
unit.
• Cycles through the dierent
preset ambient lighting settings
of the unit, this includes
dierent combinations of
colours of the ame base and
media lighting.
!
NOTE: The last theme of the
cycle is a prism where the
unit cycles through a variety
of colours. Pressing the
button stops the cycling and
holds the unit on the preferred
color, indicated by a "U" -
Unfreeze or a "F" - Freeze on
the display.
G.
Brightness
Changes the brightness of the
lights in the unit.
→ Adjusted by repeatedly
pressing the corresponding
button on the remote.
• Indicated by the second digit
on the Floating Display™
changing to show: "H" (high),
and "L" (low).
H. Sleep Timer
The Sleep Timer can be set to
automatically shut o the replace
after a preset time (from 30
minutes to 8 hours).
→ To set the timer press the timer
button on either the remote or
the unit, repeatedly, until the
desired time is displayed.
• The On-Screen Display will
display the dierent times as it
is adjusted. Once the timer has
To Next Page
Loading...
Need help?
General
