AIR FILTER
Taking off, cleaning and installation of air filter:
The air filter should be maintained on a regular basis. Keeping the air filter
clean is very important for correct engine work.
Disassembly procedure: Weaken a yoke screw supporting the filter and take the filter off.
Replace the filter. An assembly is performed recursively.
Replace a filtering element every 1000 km.
If the filtering element is installed loosely, dust and mud can get into a cylinder, at the same
time a severe abrasive wear takes place.
ALTERNATE ENGINE START
In case of accumulator battery or electric starter breakdown
the snowmobile engine may be started with the help of a reserve manual starting
system. For this it is necessary:
1) Insert a key into the ignition lock and turn it to 'ON' position.
2) Shift an engine stop button to « » position. Check a position of engine emergency
stop pin – it should be connected.
3) Shift the transmission selector lever to 'N' position.
4) Pull a reserve engine start handle smoothly up to a moment when you hear a click,
then pull it sharply. If needed, if an engine hasn't started at the first attempt,
perform this procedure once again.
35
To Next Page
Loading...
Need help?
General